Jackery F6 - decision flow
Branches and timings are Jackery's own, from the help-centre F6 articles and the Explorer 1500 / 2000 Pro manual table.
Display shows F6
What was the unit doing?
Powering a load / charging / both
POWERING A LOAD
CHARGING
BOTH AT ONCE
1. Unplug the AC load
Pull the device out of the AC output
port. Leave it disconnected.
2. Rest about 2 hours
Jackery specifies roughly two hours
to cool down fully.
3. Reset: POWER + USB, 5 s
Screen blanks, then relights. Retry the
load alone - not with others.
1. Check supply voltage
Below 200 V AC, charging will not
start at all.
2. Consider over-temperature
Long high-power use trips thermal
protection. Cool about 4 hours.
3. Reset, then resume charging
Use the gesture for your model -
5 s on most, 10 s on Pro series.
Jackery asks for three details
How it is charged (wall, solar,
vehicle socket).
Which output port is in use
(AC, DC or USB).
Name, model and rated watts of
the device being powered.
Then work the load-side branch first.
Does F6 return after the reset?
Re-test with no load, at room temperature
NO
YES
Fixed - but find the trigger
A fridge, pump or microwave inrush is
the usual cause. Start it on its own.
F6 with nothing plugged in
That is an internal inverter fault, not a
load problem. Open a warranty claim.